Prolux Electrical Contractors

MS Walk and Fun Run

admin — Fri, 18 May 2012 00:19:32 +0000

Our own Chris Reid is taking part in the 2012 MS Walk and Fun Run in order to raise funds for people affected by multiple sclerosis (MS). MS is the most common disease of the central nervous system and affects more than 21,000 Australians.

MS is very close to Chris and his family and makes this event a personal challenge.

Did you know?

* The average age of diagnosis of MS is just 30 years

* MS affects three times as many women as men

MS Australia aims to minimise the impact of multiple sclerosis on all individuals affected by the disease, as well as their families, carers and the community, by offering a wide range of services, equipment and support. MS Australia’s goal is to assist everyone affected by MS to live life to their fullest potential and secure the care and support they need, until we ultimately find a cure.

Please DONATE by clicking on the link below and help MS Australia support all people affected by multiple sclerosis.

http://register.mswalk.org.au/2012-MS-Walk-and-Fun-Run-Melbourne/ChrisReid

Powerboards, power points & extension cords

admin — Tue, 15 May 2012 01:00:50 +0000

When using power boards, power points or extensions cords it’s important to make sure you take the necessary safety precautions to minimise the risk of electric shock, severe injuries or even death. Faulty appliances with damaged or frayed cords should be thrown away or replaced. Overloading power board’s and power points will create the risk of fires, damage to property, damage to appliances/electronics and risk of severe injuries to persons. If you find yourself using too many power boards because you don’t have a power point in reach of an appliance or electronic, contact Prolux Electrical and we can discuss options of installing new power points to designated areas required in your home.

Putting safety plugs onto unused power point sockets to prevent accidental contact is one of the many safety tips we can provide your family with. To read more important safety tips to ensure your family’s safety when using extension cords, power boards or power points.
Our comprehensive safety tips for your family home:

If there is a build up of dirt, moisture, grease or oil on or around power points and switches, arrange for a registered electrical contractor to have them tested before use.
Do not spray household cleaners, detergents and insecticides on switches and power points
Do not wipe power points or switches with a wet cloth
Do not allow children to play with power points or switches
Do not plug high wattage appliances (such as heaters) into power boards as they could overheat the circuit wiring through overload and cause a fire and/or injuries to persons.
Do not place extension leads near heaters and cookers
Place extension cords carefully around furniture preferably securely taped to the floor, or along wall edges
Make sure all extension cords purchased and in use have a 3 pin plug.
Only use extension leads as a temporary measure, if you find yourself constantly having to use an extension cord, talk to your electrical contractor about installing a PowerPoint in the required area.
Extension leads that are damaged, frayed or have the inner wires exposed should be thrown away or repaired by a qualified repairman or licensed electrician
Check electrical cords are not hanging from benches where children can grab them
Do not connect a piggyback plug to the end of an extension lead to make it longer as the pins will be live. This can be extremely dangerous
If using extension leads outdoors check them regularly for signs of damage or age
Do not attempt to repair electrical leads yourself, and never join them by twisting or taping
Never place extension leads under carpet or rugs as they may overheat
Avoid using power boards in wet areas such as bathrooms or laundries.
Avoid using extension cords in wet weather or where they could contact water. If your extension cord gets wet, switch it off, unplug it from power, dry it well and check for any damage before using it again.

Today’s Project

admin — Wed, 09 May 2012 01:39:49 +0000

Nathan and Dale have taken some photos for us on what they are currently working on at Dockland Studios. Take a look!

Dockland Studios

admin — Tue, 08 May 2012 04:13:37 +0000

Change your clocks, change your smoke alarm battery

admin — Thu, 03 May 2012 00:23:03 +0000

Smoke alarms are a compulsory method to reducing the risk of injuries or death in a house fire. They are designed to save lives and protect property from the powerful destruction of fire. Smoke detectors should be installed to detect smoke before it reaches sleeping occupants, therefore its best installed near bedrooms, main living areas and of course in the kitchen. To ensure smoke alarms are effective it is important that they and regularly inspected and tested, along with maintenance to any smoke detector that requires repairs or replacement. The operation of most smoke alarms can be checked by pressing a button on the outside of the alarm. The test should be conducted in accordance with the manufacturer’s instructions. Smoke detectors must be installed directly to the power mains as well as having a backup battery, which activates when power has been disconnected from a property. The battery needs to be replaced on an annual basis; most common smoke detectors will make a warning sound when battery is low, urging you to replace it.

Interconnecting smoke alarms is an inexpensive and important safety tip to ensure all smoke alarms will activate at the same time when the risk arises.

A hardwired smoke detector needs to be wired to an electricity supply, this will require an electrician; call Prolux Electrical to discuss your smoke detector needs.

Here are a few little reminders:

All smoke alarms:

Must contain a battery
Need to be tested regularly
Need to be replaced after 10 years

How do I test and clean my smoke alarm?

Monthly: Test by pressing the test button with a broom handle
Yearly: Vacuum around your smoke alarm vents
Yearly: Replace your 9 volt battery each year at the end of daylight saving

To jog your memory *change your clocks, change your smoke alarm battery*

Vote for us in the 2012 Telstra Business Awards

admin — Thu, 05 Apr 2012 04:38:53 +0000

www.facebook.com/telstrabusinessawards VOTE PROLUX ELECTRICAL

Prolux Electrical secures new contract

admin — Mon, 02 Apr 2012 02:32:58 +0000

Dockland Studios Melbourne

Working alongside Kane Constructions this week we secured a lump sum contract to undertake electrical extension to the Docklands Studios Melbourne.
Works will commence in April 2012 and will be carefully programmed around studio operations.

Victoria University – St Albans Switchboard!

admin — Sun, 04 Mar 2012 09:00:58 +0000

New main switchboard ready for connection.

Victoria University – St Albans – Temporary Generator Supply!

admin — Sat, 03 Mar 2012 09:00:31 +0000

Whilst the substation was being upgraded, a 350kVA temporary generator supply was connected into the old main switchboard. In this photo, Dale and Nathan removing the temporary generator supply getting ready to connect new sub mains from the new main switchboard.

Victoria University – St Albans Switchboard and Fire Rated Mains!

admin — Thu, 01 Mar 2012 21:42:46 +0000

Prolux Electrical contracted to upgrade the existing 800amp supply to 1700amps at Victoria University St Albans. Works included new main switchboard and fire rated mains. Dale and Nathan pictured here connecting 8 x 400mm fire stop mains into substation LV switchboard.